EASYHOME 07177 Manual Del Usuario página 21

5. Insert the end of the thread through thread guide 1
(see Fig. 5).
6. Pull the thread from above down through the two discs of the tension regulator
for the upper thread
7. Pull the thread through the thread guide in the thread take-up (from right to left),
then through thread guide 3
the thread guide eyelet
8. Insert the end of the thread through the eye of the needle (left to right). You can
also use the needle threader
threader") (see Fig. 6).
9. Lift the presser foot lever
presser foot gap
10. Pull approx. 4" (10 cm) of thread through the gap and place it behind the sewing
machine so that the end of the thread points away from you.
• In addition to the bobbin holder, the sewing machine has a
• For a three-thread seam (two upper threads and one lower
11
and guide it through thread guide 2
26
(from top to bottom), and then finally through
24
(from top to bottom) above the needle.
6
28
5
if necessary (see chapter "Using the needle
28
until it clicks into place. Then place the thread in the
21
.
10
spool pin for the alternative use of commercially available
spools of thread as upper thread. Using the spools of thread is
similar to using bobbins. To do so, extend the spool pin all the
way out and place a spool of thread on it. Threading works the
same way as when using bobbins.
thread), use both holders at the same time. The spool pin's
thread will be threaded together with the bobbin holder's
thread.
12
(from right to left)
21
2
First use
9
.
21