Troubleshooting - Husqvarna 533RS Manual De Usuario

• Adjust the blade set to 1 mm (0.04 in) with the
recommended setting tool. Refer to the instructions
that come with the blade.

Troubleshooting

Starting failure
Check Possible cause
Stop button Stop position
Starter pawls Binding pawls
Fuel tank Incorrect fuel
type.
Carburetor Adjustment of
the idle speed.
Spark (no Spark plug dirty
spark) or wet.
Spark plug
clearance in-
correct.
Spark plug Spark plug
loose.
Fuel filter Clogged fuel fil-
ter.
Engine starts but does not stay running
Check Possible cause
Fuel tank Incorrect fuel
type.
Carburetor Engine will not
idle correctly.
1756 - 001 - 08.06.2022
Troubleshooting
Solution
Set the stop switch to the start position.
Adjust or replace the pawls.
Clean around the pawls.
Speak to an approved servicing dealer.
Drain it and use correct fuel.
Adjust the idle speed with the T screw.
Make sure that the spark plug is dry and clean.
Clean the spark plug. Check that the electrode gap is correct. Make sure that the
spark plug is installed with a supressor.
Refer to technical data for correct electrode gap.
Tighten the spark plug.
Replace the fuel filter.
Solution
Drain it and use correct fuel.
Speak to your servicing dealer.
WARNING:
Always discard a blade
that is damaged. Do not try to make a bent
or twisted blade straight and use it again.
57