Using The Product; Cleaning And Maintenance; Troubleshooting - Silvercrest SSE 6 D2 Instrucciones De Utilización Y De Seguridad

Using the product

S et the quantity of soap you want dis-
pensed for each use. Press the "+" button
or "-" button
10
desired setting is displayed. You can se-
lect from four soap quantities. The more
drops displayed in the "Soap quantity"
indicator , the more soap is dispensed.
12
H old your hand underneath the soap
outlet . The product starts dispensing
8
soap.
A s soon as dispensing stops, you can
withdraw your hand.
Note: The soap dispensing also stops
as soon as you withdraw your hand. This
is true even if the programmed quantity
has not yet been dispensed.
I f you do not intend to use the product
for long periods, press the "-" button
repeatedly until "OFF" appears in the
display .
9
P ress the "+" button
back on.
Note: If you need to remove a large
quantity of soap from the soap tank, you
can let the soap dispensing run for 30
seconds: Press the „+" button
the „-" button
hold them for about three seconds. The
product begins dispensing soap and stops
after 30 seconds. Repeat again if neces-
sary.
Note: If you have not used the product
for several days, you may have to activate
the soap dispensing function several
times in a row before soap is dispensed
again.
20 GB/IE
repeatedly until the
11
to turn the product
10
and
10
simultaneously and
11

Cleaning and maintenance

Do not immerse the product in water.
If the product will no longer be used,
rinse the empty soap container with
clean water to clean it. Fill the soap
container with clean water and repeat
several times to remove all soap.
The product may get damaged if the
soap is not removed completely.
The LED
6
T urn off the product by pressing the "-"
button
11
in the display
W ipe the product with a damp cloth. If re-
quired, use a mild detergent on the cloth.
I f one of the sensors
clean it carefully with a damp cloth.
Do not use corrosive cleaning products.
These substances may damage the basic
11
material of the product.

Troubleshooting

= Problem
= Cause
= Remedy
T he soap is dispensed slower than
usual from the soap outlet
the product does not work.
The batteries are too weak.
Replace the batteries (see "Inserting /
replacing the batteries")
Water has entered the battery compart-
ment .
4
Allow the battery compartment
dry completely. Insert new batteries (see
"Inserting/replacing the batteries").
cannot be replaced.
repeatedly until "OFF" appears
.
9
/ is dirty,
5 7
or
8
to
4