Before Use; Included Accessories; Precautions For Use - Esoteric Grandioso T1 Manual Del Usuario

Before use

Included accessories

Check to be sure the box includes all the supplied accessories shown
below. Please contact the store where you purchased this product if
any of these accessories are missing or have been damaged during
transportation.
Installation tools
Spacer block × 1
Height confirmation gauge × 1
Installation rail (L) × 1
Installation rail (R) × 1
Unit protective covers × 2
Turntable mat × 1
DC Power cord × 1
Power cord × 1
Felt pads (for power supply unit) × 4
Handles × 2
Owner's manual (this document) × 1
Warranty card × 1
Tonearm TA-9D × 1*
Tonearm TA-9D Owner's Manual × 1*
Arm base × 1*
*Not included with armless models
If an armless model is purchased, an arm base kit will also be nec-
essary. We accept custom orders for arm base kits that support
various types of arms.
Note about power supply unit installation
High-precision metal pinpoint feet are attached to the bottom plate
of the power supply unit.
The pinpoint feet and their stands are loose, but when this unit is
placed in position, it is supported by these pinpoint feet, which effec-
tively disperse vibrations.
Chassis
Foot-stand (metal)
Pinpoint foot (metal)
o Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where this unit is placed.
6
After placement

Precautions for use

o This equipment is very heavy, so take care to avoid injury when
opening the packaging and when moving it. The base unit weighs
17 kg (37 1/2 lb), the platter weighs 19 kg (42 lb), the motor unit
weighs 9 kg (19 7/8 lb) and the power supply unit weighs 18 kg
(39 3/4 lb).
o Do not place anything on top of the main or power supply units.
o Do not install these units in locations that could become hot.
This includes places that are exposed to direct sunlight or near a
radiator, heater, stove or other heating equipment. Moreover, do
not place it on top of an amplifier or other equipment that gen-
erates heat. Doing so could cause discoloration, deformation or
malfunction.
o Place the main and power supply units in stable locations.
o In order to enable good heat dissipation, leave at least 20 cm (8")
between these units and walls and other equipment when install-
ing them.
If you put them in a rack, for example, leave at least 5 cm (2") open
above and 10 cm (4") open behind them.
Failure to provide these gaps could cause heat to build up inside
and result in fire.
o The voltage supplied to the power supply unit should match the
voltage as printed on its back. If you are in any doubt regarding
this matter, consult an electrician.
o Do not open the bodies of the units as this might result in dam-
age to the circuitry or cause electric shock. If a foreign object
should get into one of the units, contact your dealer.
o When removing the power plug from an outlet, always pull
directly on the plug. Never pull on the cord itself.