Wire Loading - GYS E1 AUTO Manual De Instrucciones

Gas flow control
In the main screen, a long press on button N°1 allows you to adjust the gas flow on the manometer
without unwinding the supply wire. Once started, the proceedure is illustrated with an animation on the
screen. The gas flow setting should be checked periodically to ensure optimal welding.

Wire loading

To unwind the wire in the MIG/MAG torch without using gas, please follow the procedure below:
1- In the non-welding position, hold the trigger down without releasing it.
2- A procedure is shown automatically on the display.
3- The wire starts to feed. 3m of wire feeds at a speed of 5m/min by default. You can change these va-
lues with the thumbwheel.
Job memory and recalls
Accessible through the «JOB» icon on the main screen.
The settings in use are automatically saved and remembered the next time you turn on the machine.
In addition to the active settings, it is possible to save and recall «JOB» configurations..
There are 200 JOBS. The storage is based on the current process parameters, and the current settings.
Job
This JOB mode allows you to create, save, recall and delete JOBs.
1- Save As - Creating a Job
Customise the job name by pressing the thumbwheel. Confirm by pressing push-button no. 2.
Display the current job
At the bottom right of the screen, the job number is displayed.
Stop the current job
To close the current job, the user must return to the Job menu and select «Close».
2- Open - Jobs Management
The screen lists previously created Jobs.
Holding down push-button no. 1 deletes the active job or all jobs.
Short presssing push-button no. 1 returns to the previous menu
Short pressing push-button no. 2 allows you to see the details of each of the previously created jobs..
11