Porter Cable 310 Manual De Instrucciones página 11

73100 EDGE GUIDE KIT
The Model 73100 Edge Guide Kit is available (as an accessory) for use with
the Model 310 trimmer. The 73100 is designed for use with non-piloted
bits, on curved or straight applications. Non-piloted bits can produce a 90°
straight cut, a 10° bevel cut, or a 22° bevel cut. The kit contains the parts
shown in Fig. 2.:
A – Base and roller guide - for use with non-piloted bits
B – Edge guide – for flush trimming
C – Edge guide – for bevel trimming
D – Straight edge guide – for straight trimming
E – Guide setting gauge
F – Mounting screws
A
G – Wrench
ATTACHING AND ADJUSTING THE BASE AND ROLLER (73100)
1. Remove the power unit from the base unit (see "TO INSTALL BIT"), and
install the bit.
2. Position the base and roller guide assembly (A) Fig. 2 to the base unit. The
alignment pin on the back of the guide base fits into hole (C) Fig. 3.
3. Place the two mounting screws (F)
Fig. 2 through the guide base and
thread into sub-base holes (B) Fig. 3.
Tighten screws firmly.
4. Install the motor to the base
a n d a d j u s t t h e b i t e x p o s u re
( s e e " A D J U S T I N G T H E B I T
EXPOSURE").
NOTE: For FLUSH CUTS, adjust bit
exposure so that the straight cutting
edge (of the bit) will engage the work. For
BEVEL CUTS, adjust the bit exposure so
that the angled cutting edge (of the bit) will engage the work.
B C
Disconnect the tool from the power source!
Fig. 2
D E
Fig. 3
11
F G