Porter Cable 310 Manual De Instrucciones página 12

5. Align the roller guide with the bit by
loosening the locking screw (A) Fig.
4, and turning the adjusting screw (B)
Fig. 4, (with the hex wrench provided),
until guide is in desired location.
NOTE: For FLUSH CUTS, align the roller
with the straight portion of the bit. For
BEVEL CUTS, adjust the roller to expose
the desired amount of the bevel bit.
6. Tighten the locking screw and make a
trial cut on scrap material to check for
alignment. Readjust if necessary.
FLUSH TRIMMING
Disconnect the tool from the power source!
1. Attach base and guide to the trimmer as outlined under "ASSEMBLING
AND ADJUSTING THE BASE AND ROLLER".
2. Remove the roller guide and replace it with the flush trimming guide (B) Fig.
2. Identify this by the molded letter "F". Face the stud on the end of this
guide toward the trimmer base.
3. Install the guide setting gauge (E) Fig. 2 into the trimmer collet (see "TO
INSTALL BIT"). Install the trimmer motor to base. Adjust guide so that hole
in end of gauge may be positioned over the guide stud.
4. Remove the guide setting gauge from the trimmer and install the flush
trimming bit.
5. Adjust the depth-of-cut so that the straight portion of the bit extends below
the trimmer base at least the thickness of the material to be trimmed.
6. Make a trial cut on scrap material. Readjust if necessary.
BEVEL TRIMMING
1. Follow Steps 1 through 5 under "FLUSH TRIMMING", except install bevel
trimming guide (C) Fig. 2. Identify this guide by the molded letter "B".
2. Adjust the depth-of-cut so that only the bevel portion of the bit extends
below the trimmer base at least the thickness of the workpiece.
3. Make a trial cut on scrap material to check alignment. Readjust if necessary.
USING STRAIGHT EDGE GUIDE
The straight edge guide (D) Fig. 2 may be used with either bit for trimming
straight edges.
Attach it to the guide base and adjust similar to the other guides.
B
A
Fig. 4
12