Additional Specific Safety Rules - Porter Cable 310 Manual De Instrucciones

ADDITIONAL SPECIFIC SAFETY RULES

1. Use clamps or other practical way to secure and support the workpiece
to a stable platform. Holding the work by hand or against your body is
unstable and may lead to loss of control.
2. Tighten Collet nut securely to prevent the bit from slipping. Never
tighten collet nut without a bit. Never adjust depth of cut while motor is
running. A slip at this time may cause personal injury, or damage to cutter or
workpiece.
3. Be sure cord set is free and will not "hang up" during trimming
operations. A tangled cord could result in personal injury, or damage to
work.
4. Keep hands clear of cutter when motor is running. A moment of
inattention while operating power tools may result in serious personal injury.
5. Maintain firm grip on trimmer when starting motor to resist starting
torque. Loss of control could result, causing personal injury, or damage to
work.
6. Keep cutter clear of all foreign objects while motor is running. Provide
clearance under workpiece for the bit when through-cutting. This enables
better control of the power tool in unexpected situations.
7. Exercise extreme caution when blind cutting. Be certain that there are no
foreign objects such as electrical wire, conduit, plumbing pipes, etc., that
may come into contact with the blade.
8. Be sure motor has completely stopped before setting trimmer down
between operations. Such preventive safety measures reduce the risk of
personal injury, or damage to work.
9. Never touch bit immediately after use. It may be extremely hot.
10. Do not use Laminate Trimmer motor without the Laminate Trimmer
Base installed. Loss of control could result, causing personal injury, or
damage to work.
11. Wear eye and hearing protection. Always use safety glasses. Everyday
eyeglasses are NOT safety glasses. USE CERTIFIED SAFETY EQUIPMENT.
Eye protection equipment should comply with ANSI Z87.1 standards.
Hearing equipment should comply with ANSI S3.19 standards.
12. Use of this tool can generate and disburse dust or other airborne
particles, including wood dust, crystalline silica dust and asbestos dust.
Direct particles away from face and body. Always
well ventilated area and provide for proper dust removal. Use dust collection
system wherever possible. Exposure to the dust may cause serious and
permanent respiratory or other injury, including silicosis (a serious lung
disease), cancer, and death. Avoid breathing the dust, and avoid prolonged
contact with dust. Allowing dust to get into your mouth or eyes, or lay on
your skin may promote absorption of harmful material. Always use properly
fitting NIOSH/OSHA approved respiratory protection appropriate for the dust
exposure, and wash exposed areas with soap and water.
SAVE THESE INSTRUCTIONS!
6
operate tool in