Assembly; Operation - Porter Cable 310 Manual De Instrucciones

NOTE: This tool is shipped completely assembled. No assembly time or tools
are required.
SELECTING THE BIT
The Model 310 is equipped with a 1/4" diameter collet to accept laminate
trimming bits with 1/4" diameter shanks.
Fig. 1
G
B
A – Motor Unit
B – Base Unit
C – Sub-Base
F – Depth Adjusting Ring
TO INSTALL THE BIT
1. To remove the power unit from the base unit:
a. Loosen the clamping knob (H) Fig. 1.
b. Grasp motor unit (A) Fig. 1. Pull it straight up and out of the base unit
(B) Fig. 1. This action will release the depth-adjusting ring (F) Fig. 1,
from ring springs (G) Fig. 1.
3. Lay the power unit on the bench with the collet toward you.
4. Clean and insert the shank of bit into the collet until the end of the shank
bottoms. Then pull out approximately 1/16".
5. Place one wrench on the flats of the shaft directly above collet nut (J)
Fig. 1. Let the far end of wrench rest on the bench.
6. Place other wrench on collet nut (J) Fig. 1, and turn clockwise to tighten.
TIGHTEN SECURELY.

ASSEMBLY

OPERATION

F
A
H
C
Disconnect the tool from the power source!
H
C
G – Ring Spring
H – Clamp Knob
J – Collet Nut
K – Switch
9
K
J