iRobot Roomba Combo j7 Guia Del Propietario página 11

Cleaning the Multi-Surface Brushes
1
Pinch the Brush Frame Release Tab, lift
the Tab and remove any obstructions.
2
Remove the Brushes from the robot.
Remove the Brush Caps from the ends of
the Brushes. Remove any hair or debris that
has collected beneath the Caps. Reinstall
the Brush Caps.
3
Remove any hair or debris from the square
and hexagonal pegs on the opposite side
of the Brushes.
4
Reinstall the Brushes in the robot. Match
the shape of the Brush pegs with the
shape of the Brush icons in the Cleaning
Head module.
Cleaning the front Caster Wheel
1
Pull firmly on the front Wheel module
to remove it from the robot.
2
Pull firmly on the Wheel to remove
it from its housing (see illustration
below).
3
Remove any debris from inside the
Wheel cavity.
4
Reinstall all the parts when finished.
Make sure that the Wheel clicks back
into place.
Axle
Housing
Important: A front wheel clogged with
hair and debris could result in damage
to your floor. If the Wheel is not spinning
freely after you have cleaned it, please
contact Customer Care.
Roomba Combo™ j7 Owner's guide
EN
Wheel
7