Startup Sequence; Calibrate - Starrett 2900 Serie Manual Del Usuario

3.1 Startup Sequence

1. After the tool has shut down completely, and you have plugged it in to charge,
the tool will flash a sequence of information on the display, see the examples below
(Fig's.14-17). This is normal for the indicator and a description of the screens is shown.
2. At the end of the sequence you will re-initialize the measurement system. When
"CAL" is displayed (Fig.18), move the spindle slowly in and out, until the display starts
to show measurements. This movement will calibrate the indicator.
Fig.14 Full Lamp, shows all characters.
Fig.16 W2900 Version
Note: The information displayed above will change depending on the
indicator you are using and is only intended to serve as an example.

3.2 Calibrate

1. If you don't move the spindle, "Cal" will stay on the display for about 10 seconds
and the display will go blank.
2. To return to "Cal" mode move the spindle or quickly press the on/off button.
3. If you move the spindle to fast it will take longer for the tool to initialize
Fig.18 Calibrate the Indicator
Fig.15 Catalog Number
Fig.17 Firmware Version
ENGLISH
13