Setting The Limits (Go/No Go Function) - Starrett 2900 Serie Manual Del Usuario

ENGLISH
3 - To increment the value of the digit or the plus/minus sign;
Press
4 - To exit the Preset function:
Press

2.1 Setting the Limits (Go/No Go Function)

Note: This function is only available with the 6 button
indicators.
1. Select the units to be displayed with the IN/mm button.
2. Press the SHIFT/SET button. The SET icon will appear in
the bottom left corner Fig.6A.
3. Press the LIMITS button. The MIN LIMIT icon (MIN LIM)
will appear in the upper middle of the display Fig.6B.
4. Press the SHIFT/SET button. The LIMIT icon will flash
on/off.
5. Adjust the gauge using a reference surface to the desired
minimum value.
6. Press the SHIFT/SET button to capture the minimum
value. The LIMIT icon will stop flashing.
1 - To enter Min Limit mode.
SHIFT/SET
Press
2 - To enter the Min value.
SHIFT/SET
Press
Adjust the gauge using a reference surface to the desired minimum value.
3 - To capture the minimum value
SHIFT/SET
Press
7. Press the LIMITS button. The MAX LIMIT icon will appear in the top middle of the
display, see Fig.7.
8. Press the SHIFT/SET button. The LIMIT icon will flash on/off.
9. Adjust the gauge using a reference surface (gage block) to the desired maximum
value.
10. Press the SHIFT/SET button to capture the maximum value. The LIMIT icon will
8
PRESET
Button
PRESET
Button
Button
Button
Button
When Preset is flashing;
Then
The LIMIT icon will start flashing.
The LIMIT icon will stop flashing.
LIMITS
Button