Dust Sensor Sensitivity - SK magic ACL-25C1A Manual Del Usuario

Dust Sensor Sensitivity

The initial setting of the dust sensor sensitivity is normal.
If there is no change in the comprehensive air quality even after operating the product in a state
of high indoor air quality pollution level for about 1 hour or more, or if the indoor air quality
pollution level is high but maintains a clean state, the dust sensor sensitivity can be adjusted as
follows:
Setting the Dust Sensor Sensitivity
1. While the power is off, press and hold the
[Speed] button for 3 seconds, then press
the [Speed] button within 2 seconds of
hearing the "ding" sound.
2. Press the [Speed] button to select
Insensitive, Normal, or Sensitive modes
for the dust sensor.
The initial mode is set to Normal,
•
and each time the [Speed] button
is pressed, it will cycle between
Insensitive, Normal, and Sensitive, and
the Speed LED will change depending
on the mode.
– • (Insensitive)
When selecting the sensitivity
mode, the • (Insensitive) Speed LED
will turn on, and the dust sensitivity
will decrease.
– • • (Normal)
When selecting the sensitivity
mode, the • • (Normal) Speed LED
will turn on, and the dust sensitivity
will operate in standard mode.
– • • • (Sensitive)
When selecting the sensitivity
mode, the • • • (Sensitive) Speed
LED will turn on, and the dust
sensitivity will increase.
17