Types Of Work - Hilti TE 500-A36 Manual De Instrucciones

1. Apply a little grease to the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in
damage to the product.
2. Set the function selector switch to the "Chiseling" position
3. Push the accessory tool into the chuck as far as it will go (until it engages).
4. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶ The product is ready for use.
5. Pull the chuck ring back as far as it will go and remove the accessory
tool.

6.2 Types of work

CAUTION
Risk of injury! Loss of control over the breaker.
▶ Check that the side handle is fitted correctly and tightened securely.
Observe the safety instructions and warnings in this documentation and on
the product.
6.3 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel
positioning". Turn the function selector switch until it engages in the
"Chiseling" position.
The chisel can be set to 24 different positions (in 15° increments). This
ensures that flat chisels and shaped chisels can always be set to the
optimum working position.
1. Switch off the power tool.
2. Set the function selector switch to the "Chisel positioning" position
3. Turn the chisel to the desired position.
4. Set the function selector switch to this symbol:
▶ The product is ready for use.
6.3.1 Chiseling
▶ Set the function selector switch to the "Chiseling" position
Use both hands to hold the product firmly. Keep the product clean
and free of oil and grease.
When the product is hot after working, do not place it on readily
flammable materials. These materials can ignite.
12 English
4
until it engages.
2240496
*2240496*
.
.
.