EN
36
Remote Control Operation
A CR2025 battery is already installed in the remote control unit. Before
using, pull out the battery insulation sheet as shown below.
To replace a new battery, please refer to the figure shown below. When
inserting a battery, be sure to do so in the proper direction.
•
If the remote control conflicts with other devices, the operation will be
affected.
•
Do not simultaneously press buttons on the unit and the remote
control.
•
Avoid using two remote controls at the same time as it will cause a
malfunction.
•
Use only CR-2025 size batteries.
•
If there is battery leakage, clean the remote control thoroughly before
replacing batteries
•
Do not short two terminals of the batteries. Dispose old batteries in a
suitable place.