auna MC40 DAB Manual De Instrucciones página 40

EN
40
6. Signal Error Rate: It shows the error received. The larger this value the
more errors are received. To improve the reception adjust position of the
wire antenna.
7. Audio Bit Rate: This is the current channel audio bit rate.
Other DAB menu operations
Press the MENU button on the remote control to access the menu control.
Then press the ⏮ or ⏭ button for different options as described below.
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy
environment. The DRC level of a broadcast is set by the radio station and
transmitted with the service. Changing the DRC value on your unit enables
you to apply a scaling factor to this level.
There are three levels of compression:
• DRC high: Maximum compression as sent with the transmitted service
• DRC low: Set to 1/2 that of the sent transmitted service
• DRC off: No compression
1. Press the MENU button on the remote control to access the menu
control.
2. Press the ⏮ or ⏭ button until "DRC" is displayed and then press the
ENTER button.
3. Press the ⏮ or ⏭ button to select the DRC value and then press the
ENTER to confirm.
4. Press the MENU button on the remote control to exit the menu control.
Notes
• Not all DAB stations are able to use DRC function. If the radio station
does not support DRC then the DRC setting in the unit will have no
effect.
• After you have adjusted the DRC level the sound may be louder.
Prune
This function removes inactive stations.
1. Press MENU button on the remote control to access the menu control.
2. Press the ⏮ or ⏭ button until "PRUNE" is displayed and then press the
ENTER button.
3. Press the ⏮ or ⏭ button to select "PRUNE Y" and then press the
ENTER button to prune the unit.
4. Press the MENU button on the remote control to exit the menu control.