Before Locating The Fixing Brackets - universalblue UBE2406-21 Manual De Instrucciones

 If the hob is installed above an oven, the oven has a built-in cooling
fan
 The installation will comply with all clearance requirements and
applicable standards and regulations
 A suitable isolating switch providing full disconnection from the
mains power supply is incorporated in the permanent wiring,
mounted and positioned to comply with the local wiring rules and
regulations
 The isolating switch must be of an approved type and provide a 3
mm air gap contact separation in all poles (or in all active [phase]
conductors if the local wiring rules allow for this variation of the
requirements)
 The isolating switch will be easily accessible to the customer with
the hob installed
 Please check local building authorities and by-laws if in doubt
regarding installation
 Please use heat-resistant and easy-to-clean finishes (such as
ceramic tiles) for the wall surfaces surrounding the hob.
WHEN YOU HAVE INSTALLED THE HOB, MAKE SURE THAT
 The power supply cable is not accessible through cupboard doors
or drawers
 There is adequate flow of fresh air from outside the cabinetry to
the base of the hob
 If the hob is installed above a drawer or cupboard space, a thermal
protection barrier is installed below the base of the hob
 The isolating switch is easily accessible by the customer

BEFORE LOCATING THE FIXING BRACKETS

The unit should be placed on a stable, smooth surface (use the
packaging). Do not apply force onto the controls protruding from the
hob.
75