Polarizing Set (Optional) - Optika Italy B-60 Serie Manual De Instrucciones

3. Remove the dust cap from the bottom of the digital head.
4. Insert the digital head above the adapter and tighten the fix-
ing screw ④. (Fig. 5)
• Hold the head with one hand during the locking in order
to avoid that the head falls.
8.3

Polarizing set (optional)

1. Place the polarizer on the light exit lens ① at the base of the
microscope. (Fig. 6)
2. Using a flat screwdriver (not provided) loosen the fixing
screws on the two sides of the microscope ②. (Fig. 3)
3. Insert the analyzer in the slot inside the frame ③. (Fig. 7)
4. Put back the head into its original position and lock the fixing
screws.
Page 11
④
F F ig. 5 ig. 5
①
F ig. 6 F ig. 6
③
F ig. 7 F ig. 7