Publicidad
Handling of the blender unit
∙ Place the blender unit on the drive unit
so that
on the drive unit and
the blender unit are facing each other.
Then lock so that
other.
Always use a suitable container for
∙
operation. A tall container with a flat
base is best.
Dip the blender unit into the filled
mixture before the hand blender is
switched on.
∙
Make sure that the unit can rotate freely
inside the bowl and is not blocked during
operation.
∙
As soon as the button
the hand blender is switched off. Wait for
the motor to stop before removing the
∙
blender from the food to be mixed.
∙ Remove the mixture after use.
Multi-chopper
Place the processing bowl on the slip
∙
protection.
Caution: Exercise extreme care: the
∙
blades are very sharp. When handling
the blades, always hold them by the
upper protective plastic covering.
Cut the material to be sliced into pieces
∙
before filling the bowl with the food to be
of approximately 1 cm.
chopped.
Fit the cutting blade unit into the bowl
∙
Avoid overfilling the working tank! The
processing bowl may be filled with herbs
etc. up to the MAX mark.
Do not fill with hot liquids or hard foods
∙
(e.g. ice cubes, nutmegs, cereals, coffee
beans, rice or spices). Hard cheese or
∙
on
and
face each
is released,
chocolate is also unsuitable.
∙
Close the processing bowl with the lid
and lock it by turning clockwise.
∙ Put the drive unit on the lid of the
processing bowl. Lock by turning so that
and
face each other.
Press
and
intervals until the material to be sliced
∙
has reached the desired fineness. Hold
the lid and the processing bowl.
After chopping, wait until the motor has
stopped before opening the cover or
removing the drive unit. To loosen the
∙
drive unit, turn it until
each other. Unlock the lid, remove it and
take out the blade and the food to be
sliced.
When processing further food after the
first cycle, make sure that the receptacle
for the blade unit at the bottom of the
∙
bowl is free of food residue before
refitting the unit.
Whisk
The whisk is suitable for whipping cream
or egg whites or for mixing liquids such as
soups, sauces, etc.
∙
by twisting until
Insert the whisk into the whisk adapter.
∙
other.
Put the drive unit on the adapter. Lock
Push the whisk attachment down into
the ingredients in the bowl before briefly
switching the unit on with the operation
∙
buttons.
Always wait until the motor has come to
a complete standstill before lifting the
whisk attachment from the mixture.
∙
buttons at short
and
face
and
face each
Publicidad
