Removing The Accessory Tool - Hilti TE 700-AVR Manual De Instrucciones

DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
Check the accessory tool for damage or uneven wear each time before
use and replace it if necessary.
Use only the recommended grease supplied by Hilti. Use of unsuitable
grease may cause damage to the product.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go, turning it and
applying light pressure until it engages with an audible click.
▶ The product is ready for use.
Use only the recommended grease supplied by Hilti.
unsuitable grease may cause damage to the product.

5.4 Removing the accessory tool

DANGER
Risk of fire! Risk of contact between the hot accessory tool and highly
inflammable materials.
▶ Do not lay the hot accessory tool down on highly inflammable materials.
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Pull the chuck back.
2. Remove the accessory tool.
Use only the recommended grease supplied by Hilti.
unsuitable grease may cause damage to the product.
5.5 Positioning the chisel
The chisel can be adjusted to 24 different positions (in 15° increments).
This ensures that flat chisels and shaped chisels can always be set to
the optimum working position.
▶ Set the function selector switch to
*428076*
4
5
428076
and position the chisel as desired.
Use of
Use of
English 9