Before Initial Use - Oster BVSTKT35W Manual De Instrucciones

If you are using the kettle for the first time, it is recommended that you clean your kettle
before use by boiling a full kettle of water twice and then discarding the water.
1. To fill water into the kettle, remove it from the power base and open the lid, fill with
the desired amount of water to the kettle. Always fill the kettle between the minimum
(1.0L) and maximum (3.5L) marks. Too little water will result in the kettle switching off
before the water has boiled.
CAUTION: Do not fill the water over the maximum level, as water may spill out of the
spout when boiling. Ensure that the lid is firmly in place before connecting the power
cord to the outlet.
2. Position the kettle on the power base.
3. Connect the plug into a power outlet. Press down the switch button below the handle.
Then start to boil the water. The kettle will switch off automatically once the water has
boiled and the light extinguishes. You can shut off the power by lifting the switch at
any moment during boiling water.
NOTE: Ensure that switch is clear of obstructions and the lid is firmly closed. The
kettle will not turn off if the switch is constrained or if the lid is left open.
4. Lift the kettle from the power base and then pour the water.
CAUTION: Operate carefully when pouring the water from your kettle as boiling water
may result in scald, besides, don't open the lid while the water in the kettle is hot.
Always use both handles when pouring.
NOTE: Ensure power supply is turned off when kettle is not in use.
Should you accidentally allow the kettle to operate without water, the boil-dry protection
will automatically switch it off. If this should occur, allow the kettle to cool before filling
with cold water and re-boiling.
BVSTKT35W_22SEM2 (LA).indd 5 BVSTKT35W_22SEM2 (LA).indd 5

Before initial use

Operation
Boil-dry protect
English - 5
2022/7/6 9:40 AM 2022/7/6 9:40 AM