Saving The Battery Consumption - Pioneer DEH-P4100SD Manual De Instrucciones

Section
04 Initial Settings
1 Use MULTI-CONTROL to select TITLE in
the initial setting menu.
Refer to Adjusting initial settings on page 29.
2 Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
EURO (European language)—RUSSIA (Rus-
sian language)
# You can also perform the same operations by
pushing MULTI-CONTROL up or down.
4 Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been cancelled before
determination, operation is settled.
Saving the battery
consumption
Switching this function on enables you to save
the consumption of battery power.
! Operations other than turning on the
source are not allowed when this function
is on.
Important
If the battery in your vehicle is disconnected, the
Power Save mode is canceled. Turn on Power
Save again once the battery has been recon-
nected. If the ignition switch in your vehicle
doesn't have an ACC (accessory) position, it is
possible depending on the connection method
that when Power Save is off, the unit will draw
power from the battery.
1 Use MULTI-CONTROL to select
POWER SAVE in the initial setting menu.
Refer to Adjusting initial settings on page 29.
32
En
2 Press MULTI-CONTROL to turn the
power save on.
# To turn the power save off, press
MULTI-CONTROL again.