Setting Language; Resetting Factory Settings; Firmware Version - Avidsen 100720 Manual De Instrucciones

• Step 2: Choose Siren Duration to set the siren duration and press Enter.
• Step 3: Enter a value between 1 and 9 (mins.) and confirm with Enter.
NOTE: Siren duration default settings = 3.
Backlight time setting
• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Backlight to set the backlight duration of the central unit and press Enter.
• Step 3: Enter a value between 0 and 120 (seconds) and confirm with Enter
NOTE: Backlight Default Settings = 30.
Setting the Cycle of calls number
• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Cycle of calls to set the cycle of calls number and confirm with Enter.
• Step 3: Enter a value between 1 and 9 (number of cycles) and press Enter.
NOTE: Call-cycle Default settings = 3. This function will enable the cycle of calls that the unit
carries out to all preset numbers in case of alarm. For example, if 3 numbers are saved, the
unit starts calling numbers in sequence (1st - 2nd - 3rd) favouring the PSTN line. The cycle
will start again according to the preset Cycle of Calls. The procedure will stop if you disarm
the alarm (local or remotely).
Setting Arm Upload/Disarm Upload
• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Arm Upload and/or Disarm Upload to receive an SMS acknowledging the
arming/disarming of the central unit.

Setting Language

• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Select Language to set the language and confirm with Enter.

Resetting factory settings

• Step 1: Enter into the Main Menu and select Settings.
• Step 2: Choose Reset to restore the central unit to factory settings and press Enter.
NOTE: All system settings will be restored. Any accessory and stored phone numbers will
be deleted.
Follow this procedure to physically Reset the central unit:
1. Turn off the central unit of alarm;
2. Remove the mounting bracket;
3. Switch on the Central unit.
2. Press the anti-tamper button 5 times and within 5 seconds.
Chronology
Step 1: Enter into the Main Menu and select Chronology.
Step 2: Use the arrow keys / to scroll through all events (max view
of the last 150 events).

Firmware version

Step 1: Enter into the Main Menu and select Settings.
Step 2: Choose firmware Info to view the Firmware version and confirm with Enter.
GB
15