Automatic Power Off Function - UFESA Monza Manual De Instrucciones

Note: Please follow the operation as below to avoid the steam outlet (steam nozzle or fro-
th nozzle) being blocked after frothing milk each time: put an empty jug under the steam
wand, then turn on the steam control knob and press manual button, the pump will pump
water, after water flowing out for 30s, press manual button again to stop the pump. Clean
steam outlet (steam nozzle or froth nozzle) and steam wand sleeve with wet sponge im-
mediately, but care not be hurt!
7. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten
if desired, sprinkle the froth with a little cocoa powder.
8. Press the power button, and pull out the power plug to the power source. All indicators
will be extinguished.
Warning: After steaming, the appliance temperature is too hot and the appliance need to
be turned off and cool down at least for 5 minutes before making coffee again, or you can
activate the "Hot water" function to cool down the appliance (See "Make hot water" sec-
tion). The coffee will be burnt and there will be overflow at the funnel if the appliance brew
coffee directly without being cooled down.

AUTOMATIC POWER OFF FUNCTION

If there is no any operation within 25 minutes, the unit will power off automatically.
DESCALING
1. Disconnect the appliance from the mains supply, cut off power source.
2. Make sure the appliance has cooled down completely.
3. Remove the water tank and drip tray from the appliance.
4. Fill water tank with water and dissolved descaler solution to the MAX level (the pro-
portion of water and descale, refer to the instruction of descaler). Please use "household
descaler", instead of industrial descaler.
5. Re-fit the water tank and drip tray to the appliance.
6. Place an empty container under the brewing head to gather the descaled hot boiled
water.
7. Connect the appliance to the mains supply.
8. Press the power button and wait for the 1 cup button, 2 cup button and manual button,
to illuminate solidly.
9. Place the steam wand into a mug or jug and slowly turn the steam control knob until
water dispenses.
10. Keep dispensing to fill the mug or jug, then empty when full.
11. Repeat the process until the water tank is empty.
12. Immediately refill the water tank with clean water and repeat the process to flush the
system.
22