Installation Warnings - Ferroli EGEA 200 HT Manual De Uso, Instalación Y Mantenimiento

EGEA
200 HT - 260 HT
the consequences.
This product is heavy, handle with care and install the product in a frost-free room.
Ensure that the bulkhead can support the weight of the water filled appliance.
The destruction of the appliance by overpressure due to the blocking of the safety device inactivates the warranty.

INSTALLATION WARNINGS

When installing this product in a bathroom do not use the "Prohibited space" and respect, at least, the "Protected space"
as shown below:
Prohibited space Protected space
This product must be placed in an accessible location.
The water heater must be fixed to the ground using the fixing bracket provided for this purpose and adhesives are not
considered to be a reliable fixing means.
This product is designed to be used at a maximum altitude of 2000 m.
Refer to description and illustrations in paragraphs "6.1 Preparation of place of installation" on page 94, "6.2 Securing
to the floor" on page 95 and "6.4 Securing and connections of this appliance" on page 97.
AERAULIC CONNECTIONS WARNINGS
The simultaneous operation of an open-chamber hearth (e.g. open fireplace) and the heat pump causes a dangerous
negative pressure in the room. The negative pressure can cause the return of exhaust gases into the room. Do not
operate the heat pump together with an open-chamber hearth.
Only use sealed-chamber hearths (approved) with separate combustion air supply.
Keep tight and sealed the doors of boiler rooms that do not have the inflow of combustion air in common with living
areas.
A suitable protection grille must be installed at the air outtake connection to prevent any foreign bodies from entering
inside the equipment.
Refer to description and illustrations in the "6.3 Aeraulic connections" on page 95.
84
EN
cod. 3541T590 - Rev. 05 - 12/2021