EB TECHNOLOGY RX1 Manual De Instrucciones página 4

RX1
CODE MANAGING
The receiver can manage standard codes from 12 up to 64 bits and rolling codes HCS. The fi rst remote
control you learn, determines the type of code you get in.It is possible to activate or deactivate the rolling
code counter. This is for a safe installation.
ACTIVATE OR DEACTIVATE THE ROLLING CODE COUNTER
This operation is necessary to activate or remove the key's control and the rolling code counter. If you
active this control , the receiver will accept ONLY the rolling code with owner key (producer key) and will
control the rolling counter, in a way that the tranmitter cannot be copied.
The operation is as follow:
1. Make sure that the receiver outputs are removed and are not in learning
2. Press and release the button.The red led is lighting.
3. Press and release the button.The red led is fl ashing and lighting .
4. Press and release the button. The red led is switched off and it turns off if the rolling code counter is
deactivated while it fl ashes constantly or it fl ashes if the rolling code counter is activated.
MEMORIZATION OF THE REMOTE CONTROL
To learn a code make as follow:
1. Make sure that the receiver output is not activated
2. Push and release the button The red led is lighting
3. Push the transmtter's button within 5 sec.If the code has been learnt the red led is fl ashing shortly.
If the red led is fl ashing slowly it means that the memory is full. If the red led is not fl ashing it means
that the transmitter is not compatible
STEP-BY-STEP FUNCTION
The output of the receivercan be set up for step-by-step function (activated or not activated). To activate
or deactivate this function it is suffi cient to press the button when the output is activated. If the output is
in standard mode, the step-by-step function will be activated, if it was in step-by-step mode, it will be in
standard mode.
CANCELLATION OF A SINGLE TRASMITTER
This operation can cancel one single transmitter.
1. Press and release the button. The red led is lighting .
2. Press the transmitter's button. If it is already learnt, the red led will fl ash for 3 seconds to change
into the standard mode. In this time press the button again.
-4-
Operation guide