Tabla de contenido
Publicidad
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not
work
The food is too warm
Appliance cools too
much
Unusual noises
Water on the floor
Side panels are hot.
If the malfunction shows again, contact the Service Center.
Possible cause
Temperature regulation knob is
set at number "0".
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature
is
not
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Water drain hole is blocked.
It's normal. Heat exchange parts are
in the sides.
60
Set the knob at other number to
switch on the appliance.
Insert mains plug.
Check
fuse,
necessary.
Mains malfunctions are to be
corrected by an electrician.
properly
Please
look
Temperature Setting section.
Open the door only as long as
necessary.
Turn
the
regulation to a colder setting
temporarily.
Please look in the installation
location section.
Turn the temperature regulation
knob
to
temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
See the Cleaning and Care
section.
Take gloves to touch sides.
Solution
replace
if
in
the
initial
temperature
a
warmer
setting
Publicidad
Tabla de contenido
