Jocel JEGA007605 Manual De Instrucciones página 27

Campana extractora
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Controls:
Motor switch
Lamp switch
The telescopic board controls electrical power, just pulling out of the telescopic board, the hood can
get electronic power, pull into of the telescopic board, the hood has no power.
And then, both side and under the front panel is both switches for lamp and motor. The lamp switch:
Press the switch button on "0", the lamp is not light; Press the switch button on "I", the lamp is light;
The others side, it is the switch of motor: "0" is not working position; Press the switch button on "I",
the motor runs at the low speed; Press the switch button on "II", the motor runs at the high speed.
Information
Do not touch the light bulb within half an hour after appliance use. The lamp shall not be covered
with thermal insulation or other material.
If the supply cord is damaged, it must be replaced by the manufacturer its service agent or similarly
qualified persons in order to avoid a hazard.
27

Publicidad

Tabla de contenido
loading

Tabla de contenido