Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Spare parts
The following spares are available from
Service-Center (see P. 65 for the address).
Please indicate the machine type and the
number of the spare part with your order.
Spare blade ...............................13700300
If further spare parts should be necessary,
please find the part number on the exploded
drawing.
Technical
Specifications
Electric Lawnmower ......... FRM 1800 A1
Motor input power ......................... 1800 W
Mains voltage ......................230V~, 50 Hz
Idling speed .............................. 3250 min
Blade width ..................... Approx. 440 mm
Cut height ...............................20 – 70 mm
Protection class ...................................
Protection type.................................. IP 24
Weight ...........................................18.7 kg
Lawn bag volume ................................ 50 l
Sound pressure specification
(L
) ............ 74.8 dB(A); K
pA
Noise level specification
measured
(L
)
WA
.................. 93.9 dB(A); K
guaranteed ............................96.0 dB(A)
Vibration on the handle
(a
) ...................... 2.07 m/s
n
Do not exceed the maximum permitted
network impedance of 0.277 Ohms at the
electrical connection point
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure as-
sessment.
48
The noise and vibration values have been
determined in accordance with the stand-
ards and regulations specified in the decla-
ration of conformity.
Technical and visual modifications may be
made without notice in the course of further
-1
development. All dimensions, informa-
tion and specifications in these operating
instructions are therefore not guaranteed.
II
As such, no assertion of legal claims can
be enforced on the basis of the operating
instructions.
= 2.26
dB(A)
pA
=2.26
dB(A)
wA
; K= 1.5 m/s²
2
Warning: The vibration emission
value may differ during actual use of
the power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the op-
erating cycle are to be considered,
including, for example, times during
which the power tool is turned off
and times when the tool is turned on
but is running idle).
Publicidad
Tabla de contenido
