Front Panel - DIEL ME 200 E Manual De Instalacion Y Uso

Terminals 35-36: FAN B relay is
predisposed for the managing of
transformer cooling fans or for the
conditioning of the place where the
transformer is located.
Terminal 37: Ethernet port RJ45
connector
Terminals AL1-GND-AL2:
control unit can be powered with
(24÷240) Volt AC/DC ± 10% 50-60
Hz without polarity compliance.
All measurement signal transmission cables should preferably be:
• separated from the power ones.
• better shielded if also stranded.
• of section not less than 0.5 mm².
Off
Blink
Off
On
Off
On
Off
ME 200 E
The

FRONT PANEL

Display the channel and
its temperature.
Display transmission
data.
Signal that at least one
probe has detected that
the set value of the
threshold P has been
exceeded by at least 1
degree.
Signal that at least one
probe has detected that
the set value of threshold
A has been exceeded by
at least 1 degree.
Report a probe fault.
>> Paragraph THERMOMETRIC PROBES DIAGNOSTICS
- 22 -
ENG