Assembly And Installation - universalblue UVT1339-22 Manual De Instrucciones

Note: The picture is for reference only. The
content may vary depending on the model.
Packaging content:
1. Screws and washers for securing the
blades (fixed on the motor housing).
2. Screws for concrete ceiling
3. Screws and washers for wood joist
ceiling
4. Balance kit
5. Upper canopy
6. Support plate
7. Support rod
8. Lower canopy
9. Motor + Led light kit
10. Light cover
11. Remote control
12. Lamp shade
You can check the product features in table
01 on page 9.

ASSEMBLY AND INSTALLATION

Before
appliance, make sure that
the
unplugged
mains. Also disconnect
the electrical current from the
installation of your home. See
picture 02 on page 5.
Before starting with the assembly
we recommend to find the serial
number and save it. You can find
this number, referred to as "S/N"
in a label pasted on the outside of
the motor housing. You can write
down this number in the warranty
document. It is mandatory to
provide the serial number to
the Technical Service for any
intervention. (see picture 08 on
page 7)
WHERE TO INSTALL: (see picture 03 on
installing the
appliance
from the
page 5)
• Make sure that the place where the fan
is going to be installed is quite wide, as
this will allow a better air flow and that
the fan blades do not come into contact
with any object, minimum space of
0.6m on each side.
• Do not place the fan in an open space,
or in a room where there is moisture or
exposure to water.
• If the chosen location does not have
a suitable support beam capable of
supporting 45Kg, install a 2"x4" support
between the roof beams as a support
medium.
• Make sure that the bracket for hanging
the fan to the ceiling or other suitable
structure is capable of supporting at
least 45Kg, with the two long fixing
screws included. Make sure that at
least 30 mm of the screw is screwed
into the bracket.
• Only the fans with a support rod or bar
can be installed on sloping roofs where
the angle of inclination does not exceed
25º. This model cannot be installed on
sloping roofs.
is
Our fans are not designed to be
installed in plasterboard or
false ceiling, as these materials
may not support 45kg.
Note: Fastening screws (included) are
designed for use with the fan and are
fastened to wooden beams or concrete
ceiling. If the installation is carried out on a
different material, it is advisable to use the
appropriate fixing screws for that material
(these screws are not supplied with this
equipment). ornillos no se suministran con
este equipo).
STEP BY STEP
Here at UniversalBlue we have
created videos to explain the
assembling process. You can
find them in our YouTube
channel, by clicking on the
following link, or scanning this QR code.
EN
23