Environmental Protection; Technical Specifications - Metabo MA 36-18 LTX BL Q Manual Original

en ENGLISH
9.2 Lubrication
Lubrication is not required.
10. Problems
When attaching to the cordless multidrive, the
rod ends cannot be pushed into each other.
- See chapter 7.1.
The machine cannot be switched on again.
- See chapter 7.3.
11. Accessories
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
A Battery packs with different capacities. Buy
battery packs only with voltage suitable for your
power tool.
4.0 Ah (LiHD), order no.: 625367000
5.5 Ah (LiHD), order no.: 625368000
8.0 Ah (LiHD), order no.: 625369000
etc.
4.0 Ah (Li-Power), order no.: 625027000
5.2 Ah (Li-Power), order no.: 625028000
etc.
B Chargers: ASC 55, ASC 145, ASC 145 DUO,
etc.
C Hedge trimmer attachment, MA-HS 50, order
no.: 601726850
D Pole pruner attachment, MA-MS 25, order no.:
601727850
E Brush cutter and grass trimmer attachment,
MA-FS 40, order no.: 601728850
F Shaft extension, order no.: 628498000
G Universal tool bag (long), order no.: 626910000
For a complete range of accessories, see
www.metabo.com or the catalogue.
12. Repairs
Repairs to electrical tools must only be carried
out by qualified electricians and only with
original spare parts!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

13. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
12
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).

14. Technical Specifications

Explanatory notes regarding the specifications on
page 4.
Subject to change in accordance with technical
progress.
U = voltage
m = weight (with smallest battery pack, without
carry strap)
Values measured as per EN
Note: Technical data depends on the attachment
fixed. Read the operating instructions supplied with
the attachment.
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
Recommended ambient temperature when
charging: 0 °C to 40 °C
direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
62841.