Environmental Protection; Technical Specifications - Metabo KFM 15-10 F Manual Original

13. Repairs
Repairs to power tools must only be carried
out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.

14. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
tools, packaging and accessories.
Only for EU countries: never dispose of
power tools in your household waste! Used
power tools must be collected separately and
handed in for environmentally compatible recycling
in accordance with European Directive 2012/19/EU
on waste electrical and electronic equipment and its
implementation in national legal systems.

15. Technical Specifications

Explanatory notes regarding the specifications on
page 4. Subject to change in accordance with
technical progress.
n = No-load speed (maximum speed)
P = Rated input power
1
P = Power output
2
h = Max. chamfer height
max
b = Max. chamfer width
max
a = Chamfer angle
d = Minimum pipe diameter
min
m = Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
AC power
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a =Vibration emission value
h, SG
K =Uncertainty (vibration)
h,SG
Typical A-weighted sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K , K =Uncertainty
pA WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
Electromagnetic disturbances:
In individual cases, the speed may fluctuate
temporarily if the machine is exposed to extreme
external electromagnetic disturbances or the
electronic restart protection may respond. In this
case, switch the machine off and on again.
ENGLISH en
19