universalblue UAS1900-20 Manual De Instrucciones página 50

HEAT MODE
The cold function allows the air in the room to warm up.
To activate the HEAT function, press the MODE button until the
symbol appears on the screen.
Adjust the temperature using the
To optimize the operation of the unit, adjust the temperature (1), the speed (2) and the
direction of the air flow (3) by pressing the indicated button.
• If the appliance is equipped with a heat pump, it may take a few seconds to
switch on the appliance in order to guarantee an immediate output of hot air.
• During the HEAT mode, the appliance can automatically activate a defrost cycle,
essential to clean the frost in the condenser and operate properly. This
procedure usually takes 2 to 10 minutes and the indoor unit will stop. The HEAT
mode will start automatically after defrosting.
To activate the COOL function, press the
MODE button until the
symbol appears on the screen.
Adjust the temperature using the
down arrows.
To optimize the operation of the unit, adjust
the temperature (1), the speed (2) and the
direction of the air flow (3) by pressing the
indicated button.
up and down arrows.
COOL function
up and
HEAT function
50