Indoor Unit Installation - universalblue UAS1900-20 Manual De Instrucciones

Tips for correct installation:
The place of installation should be a well ventilated room.
•
• Installation place must be free of open fuel and any source of heat greater than
548 ° C that easily emits gases and fumes.
• It is necessary to choose the place where the installation or maintenance is
convenient and where the air inlets and outlets are perfectly uncovered and not
obstructed.
• If the indoor unit suffers a refrigerant leak during installation, it is necessary to
immediately shut off the outdoor unit valve and empty the staff room for at least
15 minutes. If the product is damaged, before installation please repack the
product and contact the supplier.
• It is necessary to avoid placing the indoor unit directly above other electrical
appliances, plugs, furniture, beds, sofas or other furniture.

INDOOR UNIT INSTALLATION

• Install the indoor unit on a strong wall that is not subject to vibration.
• The ports of entry and exit must not be
obstructed: the air must be able to run in
the room.
• Do not install the unit near a source of
heat, steam, or flammable gas.
• Install the unit near an electrical outlet.
• Do not install the unit in places exposed
to direct sunlight.
• Select a location where condensed water
can be easily
connected to the outdoor unit.
• Regularly check the operation of the
machine and reserve the necessary
space for installation, as shown in the
picture.
• Select a location where the filter can be
easily removed.
• Before starting the installation, decide
the position of the indoor and outdoor units, taking into account the minimum
space reserved around the units.
• Do not install your air conditioner in a damp room such as a bathroom, laundry
room etc.
• The indoor unit must be installed at a minimum height of 250 cm.
To install the indoor unit, proceed as follows.
drained and easily
56