Identifying The Parts - Mobiclinic VIRGO Manual De Instrucciones

Instruction Manual VIRGO
ES EN FR IT DE PT NL SWE PL DK
OTHER OPERATING INFORMATION
Hill climbing: You may need to use a higher speed. Turn to lower speed before going downhill.
Down slopes: To proceed down steep slopes slowly, set speed control in proximity of the turtle. This enables driver
control, as the closer the speed control is set toward the turtle, the slower it will become. However, this scooter will not
self-accelerate down hills due to the automatic braking taking effect should you attempt to drive too fast.
If the scooter breaks down and must be moved, get off the scooter, push the Free-Wheeling Lever to N, move the
scooter slowly to a safe location, and move the lever back to D.

IDENTIFYING THE PARTS

FUNCTION OF PARTS
Top control panel
1. Speed Control Knob: The Rabbit means fast and Turtle is slow. By turning this, you control the total speed transferred
to the thumb controls.
2. Self Diagnostic Warning Light: Flashing indicates problems with the scooter.
3. Battery Gauge: This light is yellow. Below you will find three color ranges: red, yellow and green. When the light is on
in all three color ranges, the batteries are fully charged. When the light is on only in the red, or red and yellow areas, the
batteries need to be recharged.
Beneath top control panel
1. Throttle: Pushing the right Throttle moves the scooter forward. Pushing the left Throttle moves the scooter backward.
(This can be reversed if required by local dealer.) Releasing both engages the automatic brake. This is also your
accelerator. The further you depress them, the faster you go. (Subject to the position of the Rabbit/Turtle control).
At base of steering tiller
1. Adjust the steering handlebars: Push down on the handlebars to adjust them. Pull up to lock the turn of the steering
column at an angle that is comfortable for you.
11