Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enable range
Disable range
Deleting the
ON
range
S1
1 2 3 4
4.5 DOOR ENTRY MONITOR RINGTONE SELECTION ART. EX-7000H
1.
Press and hold
for 6 sec.
» a confirmation tone will sound
» the Privacy LED will flash to indicate "programming" mode.
√ The procedure can only take place while the system is in standby; otherwise the Privacy LED will flash 4 times to inform the user that the
system is engaged.
2.
Press and release
:
Once (1 confirmation tone is emitted) to change the ringtone for calls from the external unit.
Twice (2 confirmation tones are emitted) to change the ringtone for calls from the switchboard.
3 times (3 confirmation tones are emitted) to change the ringtone for intercom calls made from the internal unit.
4 times (4 confirmation tones are emitted) to change the floor door call ringtone.
Any further pressing of the
3.
Press and release
to scroll through the various available ringtones in sequence.
4.
Press
to confirm selection of the last ringtone heard and to exit (at any time) change monitor ringtone mode.
» one confirmation tone is emitted
» the Privacy LED switches off
5.
Repeat steps 1 to 4 to change the other ringtones.
4.6 CONFIGURATION EX-B
4.6.1 External unit addressing
„ Set the S1 DIP-switches corresponding to the address that you want to set as shown in the table below
EXTERNAL UNIT ADDRESSING
CODE
DIP 1
0
OFF
(default)
1
ON
2
OFF
3
OFF
24
ON
S2
1 2 3 4
5
6 7
5
6 7
8
key repeats the sequence described above.
DIP 2
DIP 3
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
8
2 sec
ON
1 2 3 4
5
6 7
8
ON
1 2 3 4
5
6 7
8
ON
1 2 3 4
5
6 7
8
ON
1 2 3 4
5
6 7
8
ON
S2
1 2 3 4
5
6 7
8
Publicidad
Tabla de contenido
