How To Wire Your Ceiling Fan - Fanimation LP3071 Serie Manual De Instrucciones

NOTE: Factory setting is all up. Do not use this
position.
1. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference
from or to other remote units, simply change the
combination code in the remote and receiver.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket before
wiring as shown in figure 3.

How to Wire Your Ceiling Fan

Receiver
Hanger Bracket
Receiver
NOTE: Supply wires
omitted for clarity.
11
Remote Control
ON DIP
1 2 3 4 5
Dip Switch
Figure 1
Main Fuse Box
Figure 2
Figure 3