How To Hang And Wire Your Ceiling Fan - Fanimation KWARTET FPS8553 Serie Manual De Instrucciones

How to Hang and Wire Your Ceiling Fan

WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging and
wiring. (Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
The fan must be hung with at least 7´ of clearance
from floor to blades. (Figure 2)
WARNING
It is critical that the outlet box and the screws are
securely anchored to the building structure and
capable of withstanding a load of at least 35 lbs.
Failure to verify that the screws are properly installed
could result in the fan falling.
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may
result in damage to the fan blades.
1.
Securely attach the outlet box acceptable for ceiling
fan support into the building structure. Outlet box is
not supplied with the fan. (Figure 3)
2. Remove the three screws from the ceiling bracket
assembly and retain for later. (Figure 4)
3. Using the 3/8˝ x 2˝ lag bolt and flat washer, attach
safety cable to ceiling joist or wood structural member.
The lag bolt will pass through the flat washer, safety
cable loop, and into the building structure (Figure 5). You
will first drill a ¼ ˝ pilot hole into the building structure to
prevent splitting or cracking.
4. The ceiling support cable need to pass through the
center hole of ceiling bracket when mounting. Using
the two #8-32 screws and washers securely attach
the ceiling bracket to ceiling outlet box as shown.
(Figure 5)
Ceiling
Floor
NOTE: Supply wires and
fan wires omitted for clarity
NOTE: Supply wires and
fan wires omitted for clarity
Wood Member
(2 ˝x 4˝Approx.)
Ceiling
Ceiling Support
Cable
NOTE: Supply wires and
fan wires omitted for clarity
7
Main Fuse Box
Figure 1
No Less
Than
7 Feet
Figure 2
Outlet Box
Figure 3
Ceiling Bracket
Assembly
Figure 4
Outlet Box
Ceiling Joist
3/8˝ x 2˝ lag bolt
Screws (2)
and flat washer
Supplied with
Outlet Box Ceiling Bracket
Figure 5