Maintenance And Storage; Work Area Safety; Electrical Safety - GreenWorks GD40BV Manual De Instrucciones

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
objects are not included.
„ If the cutting mechanism strikes any
foreign objects or if the machine should
start making any unusual noise or
vibration, immediately shut off the power
source and allow the machine to stop.
Disconnect the machine from the supply
and take the following steps before
restarting and operating the machine: i)
inspect for damage;
1) replace or repair any damaged parts;
2) check for and tighten any loose parts.
„ Do not allow processed material to
build up in the discharge zone; this may
prevent proper discharge and can result
in kickback of material through the intake
opening.
„ If the machine becomes clogged, shut-
off the power source and disconnect the
machine from supply before cleaning
debris.
„ Never operate the machine with defective
guards or shields, or without safety
devices, for example debris collector in
place.
„ Keep the power source clean of debris
and other accumulations to prevent
damage to the power source or possible
fire.
„ Always stand clear of the discharge zone
when operating this machine.
„ Stop the machine, and remove battery
pack. Make sure that all moving parts
have come to a complete stop
- whenever the machine is left by the user;
- before clearing a blockage;
- before checking, cleaning or working on the
machine;
- after striking a foreign object to inspect the
machine for damage;
- if the machine starts to vibrate abnormally,
immediately check;

MAINTENANCE AND STORAGE

„ Keep all nuts, bolts and screws tight to
be sure the appliance is in safe working
condition.
„ Replace worn or damaged parts.
„ Use only genuine replacement parts and
accessories.
„ Store the machine in a dry place out of
the reach of children.
English (original instructions)
„ Do not to touch moving hazardous parts
before the machine shuts down and the
moving hazardous parts have come to
a complete stop. Allow the machine to
cool before making any inspections,
adjustments, etc. Maintain the machine
with care and keep it clean.
„ Always allow the machine to cool before
storing.
„ When servicing the shredding means be
aware that, even though the power source
is switched off due to the interlock feature
of the guard, the shredding means can
still be moved.
„ Never attempt to override the interlocked
feature of the guard.
„ Store indoors, and do not expose to rain
or water, avoid direct sunshine.
Use only the manufacturer's replacement
parts. Failure to do so may cause poor
performance, possible injury and may void
your warranty.
The term "power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.

WORK AREA SAFETY

„ Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
„ Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power
tools create sparks which may ignite the
dust or fumes.
„ Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control.

ELECTRICAL SAFETY

„ Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators. There
is an increased risk of electric shock if
your body is earthed or grounded.
„ Do not expose power tools to rain or wet
conditions. Water entering a power tool
will increase the risk of electric shock.
2
WARNING