remove all detergent residue and dry with
a cloth.
Immediately after using the steam function,
clean the steam wand with a cloth. Activate
the steam function to prevent clogging
inside the wand.
If the steam wand does get clogged, use a
needle to clear it.
Use a soft and damp cloth to clean the
exterior of the coffee machine.
Cleaning mineral residues/
descaling
The accumulation of mineral residues in
the water circuit can affect the functioning
of the coffee machine. It is very important
to clean the water circuit to keep the
machine functioning efficiently. The quality
of the water used and the type of use will
determine the frequency with which you
will have to clean these residues.
It is recommended to perform cleaning
cycles after every approximately 300
coffees. The machine will indicate that
cleaning is needed when the control panel
buttons blink 3 times and the machine
emits an alert sound after being turned on.
To clean the water circuit, proceed as
follows:
Place 10g of lemon juice (or citric acid) in
the water tank and add water to the MAX
fill line.
Press the ON/OFF button. The coffee
buttons will blink and the machine will
begin warming up. When the coffee buttons
stop blinking, the machine is warmed up.
The ON/OFF button will continue to blink.
Place a container under the steam wand.
Rotate the steam adjustment knob to the
steam/hot water position (
22
The process will begin and the pump will
operate for 2 minutes, pushing the solution
through the water circuit. After 2 minutes,
the machine will stop.
Rotate the steam adjustment knob to the
CLOSED (
Place a container on the cup rack.
With the portafilter removed, press the
double coffee button once the coffee
buttons have stopped blinking.
Remove the water tank and wash it
carefully. Fill it to the MAX fill line.
Repeat the operation from step 3 until step
7. The circuit is clean.
Press and hold the single coffee and double
coffee buttons for 2 seconds. The ON/OFF
button will stop blinking.
).
www.flama.pt
) position.