Publicidad
Step 11
å
Slide the LOWER END MOLDING (L) onto the
RIGHT END (A). Line up the groove in the MOLDING over
the heads of the SCREWS in the RIGHT END.
å
NOTE: The MOLDING should be even on both edges of
the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
www.sauder.com/service
A
426133
L
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the ENDS.
Page 17
Publicidad
