Tabla de contenido
Publicidad
Step 4
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (B and C). Use twelve 1/2" PAN HEAD SCREWS (21) shown in the
enlarged diagram.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole indicated in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other holes that lines up with the hole in the END. Turn a SCREW into
these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Open end
2
Pull up or down the black lever in
and pull the SLIDE from the RAIL.
Open end
427346
1
B
1
www.sauder.com/service
Put the SCREW
into this hole first
1
21
1/2" PAN HEAD SCREW
(12 used in this step)
1
C
7
Open end
1
Page 9
Publicidad
Tabla de contenido
