Publicidad
Step 30
å
Pull the SMALL DRAWER FRONT BRACKETS (7G) apart and slide them into the grooves in the
SMALL DRAWER SIDES (D53 and D59). You may need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH" for easy identification.
å
Fasten the SMALL DRAWER FRONT (N) to the DRAWER FRONT BRACKETS (7G). Use two
BLACK 9/16" LARGE HEAD SCREWS (1S).
å
Slide the SMALL DRAWER BOTTOM (D707) into the grooves in the
DRAWER SIDES (D53 and D59) and DRAWER FRONT (N).
å
Fasten the SMALL DRAWER BACK (D109) to the DRAWER SIDES (D53
and D59). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
BLACK 9/16" LARGE HEAD SCREW
(2 used for the BRACKETS)
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
e d
D707
D53
N
Page 36
1S
s u r
f a c
e
D59
N
D59
D53
D109
D53
427720
Push down
7G
Groove
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
D59
the DRAWER
BACK groove.
www.sauder.com/service
Publicidad
