Publicidad
Step 35
å
Insert the GROMMETS (10P) and GROMMET CAPS (1P) into the large holes in the TOPS (C and D).
å
To insert the SMALL DRAWER into your unit, tip the front of the drawer down and drop the rollers on the drawer behind
the rollers on the unit.
å
To insert the LARGE DRAWER into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS
on the unit and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the
way in, then it will slide in and out easier.
Place the roller on the SLIDE
behind the roller on the RAIL.
www.sauder.com/service
D
Drawer Slide
To adjust the DRAWER FRONT using
the DRAWER SLIDE, loosen the SCREW
in the oval hole, adjust the drawer up or
down as needed, then tighten the SCREW.
427720
1P
10P
C
Adjust the
drawer up
or down.
Page 41
Publicidad
