Publicidad
Step 32
å
Pull the LARGE DRAWER FRONT BRACKETS (10G) apart and slide them into the grooves in the LARGE
DRAWER SIDES (D32 and D33). You may need to gently tap them in with a hammer and screwdriver.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH" for easy identification.
å
Fasten the LARGE DRAWER FRONT (U) to the DRAWER FRONT BRACKETS (10G).
Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
å
Slide the LARGE DRAWER BOTTOM (D708) into the grooves in the
DRAWER SIDES (D32 and D33) and DRAWER FRONT (U).
å
Fasten the LARGE DRAWER BACK (D78) to the DRAWER SIDES (D32
and D33). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
BLACK 9/16" LARGE HEAD SCREW
(4 used for the BRACKETS)
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
e d
s u r
D708
D33
U
Page 38
1S
f a c
e
D32
U
D32
D33
D78
D33
427720
You may need to use
your hammer and
screwdriver to gently tap
down into the groove.
10G
10G
Groove
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
D32
the DRAWER
BACK groove.
www.sauder.com/service
30S
Publicidad
