Installation - Dometic DE 15F Instructions De Montage Et De Service

Installation

6 Installation
!
WARNING! Electrocution hazard
Ensure that electrical connections comply with state and local codes.
6.1 Mounting the handles
➤ Proceed as shown (fig. 0, page 7fig. 7, page 6).
6.2 Inserting the shelf supports
➤ Proceed as shown (fig. a, page 8fig. 8, page 6).
6.3 Inserting the shelves
➤ Proceed as shown:
– DE15F, DE24F: fig. b, page 8
– EA15F, EA24F: fig. c, page 9fig. 9, page 7
– EA24B: fig. d, page 9fig. 0, page 7
6.4 Selecting the installing location
!
WARNING! Risk of injury
Move the device with at least 2 people.
Observe the following, when selecting the installation location:
• The ambient temperature should be in accordance with the climate class. Other-
wise the set internal temperature cannot be reached or maintained. This can also
be the case with extreme fluctuations in the ambient temperature.
The intended ambient temperature and the climate class can be found in the
technical data (see chapter "Technical data" on page 40) and on the data plate
of the device.
• The ground must be level and sufficiently stable to support the device when fully
loaded.
• The device must be positioned so that the plug is accessible.
• Note the information on the electrical connection (chapter "Connecting the
device to the power supply" on page 29).
• Do not install the device in an area with excessive moisture.
➤ Remove all the inner and outer packaging material before setting up the device.
28
DE15F, DE24F, EA15F, EA24B, EA24D, EA24F
EN