Troubleshooting - Dometic DE 15F Instructions De Montage Et De Service

DE15F, DE24F, EA15F, EA24B, EA24D, EA24F
11

Troubleshooting

Fault
The device does not
work.
The device is not
cold enough.
EN
Possible cause
The device is not connected to a
power supply.
The device is switched off.
The circuit breaker tripped.
The fuse has blown.
The temperature is not set prop-
erly.
The ambient temperature could
require a higher temperature set-
ting.
The door was opened frequently. ➤ Do not open the door more
The door was not closed prop-
erly.
The door is not hermetically
sealed.
The condenser is too dirty.
The ventilation opening is
blocked.
Troubleshooting
Remedy
➤ Connect the device, see
chapter "Connecting the
device to the power supply"
on page 29.
➤ Switch the device on, see
chapter "Switching the
device on/off" on page 32.
➤ Switch on the circuit breaker.
➤ Replace the fuse.
➤ Check the set temperature.
➤ Set a higher temperature (see
chapter "Setting the tempera-
ture" on page 32).
often than necessary.
➤ Close door properly.
➤ Check the door seal and clean
it.
➤ If necessary, contact an autho-
rized service agent to replace
the seal.
➤ Clean the condenser.
➤ Clean the ventilation open-
ings.
35