11. Trademark and Legal Statement
EN
is the trademark of Brightway Ltd. All rights reserved.
12. Safety Warning
CAUTION
Danger! Read user manual before use.
CAUTION
Do not disassemble battery cover,
hazardous energy inside.
18
CAUTION
Sharp Edges. Do not touch the sharp
edges or corner.
CAUTION
Hot Surface! Do not touch the surface
near this symbol.
13. Certification
FCC Supplier's Declaration of Conformity
This supplier's declaration of conformity is hereby for
Product: NAVEE Electric Scooter S65
Model Number(s): NKP2223-B32
Brand/Trade: NAVEE
We declare that the above mentioned edvice has been tested and found in compliance with CFR 47 Part Regulation.
Responsible Party—U.S.Contact Information
Company: Brightway Innovation Intelligent Technology (Suzhou) Co., Ltd.
Address: Building A2, Shangjinwan Headquarters Economic Park, No.2288, Wuzhong Avenue, Wuzhong Economic
Development Zone, Suzhou Jiangsu P.R. China
Country: China
FCC Compliance Statement for USA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
EN
19