Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Charging
EN
The scooter is fully charged when the LED on the battery charger changes from red to green.
Charging Port
LED Indicator
Light
WARNING!
Only use the original battery charger to avoid potential damage or fire. Switch off the vehicle or into a certain non-
·
operational mode during charging.
Do not charge when the charging port or power cord is wet. If the battery is damaged or soaked with water , it is
·
forbidden to charge or continue to use the battery.
6. Check Before Riding
Before each ride, please check the status of your scooter,
including tire performance, remaining battery level and
scooter body state, and ensure that no part is loose or
damaged.
08
1. Lift up the
3. When charging is
2. Plug the battery
rubber flap.
charger into the
completed, put back
the rubber flap.
charging port.
WARNING: Wear a helmet, elbow pads and knee pads
before riding.
7. Start Riding
Important! There will be falling and injury risk while studying, please wear helmet and safety gear at all times.
1. Step on the deck with one foot, and slowly kicks off the
other on the ground.
Note: For your safely, the accelerator can be used once
the scooter is going over 5 km/h.
V≥5km/h
3. Release the accelerator to slow down, and squeeze
the brake lever for a sudden brake.
WARNING: Sudden braking may cause you to lose traction, fall and serious injury, maintain moderate speed and be
aware of potential hazards.
2. Put your other foot on the deck to keep both feet
stable, and gently press the accelerator.
Note: When riding, hold the handlebar tightly with both
hands to avoid injury, or any falls due to loss of balance.
4. Tilt your body to the steering direction as you turn, and
slowly turn the handlebar.
EN
09
Publicidad
Tabla de contenido
